What should I do if the equipment gets into the water after the rainstorm?

There are many heavy rains in spring, if you are careless, the equipment has different degrees of water ingress, so how to deal with it? Brother Chong will teach you today!

Once the equipment is flooded, there are many hazards. Moisture will destroy the oil film formation, make the oil film that has already formed thinner, greatly reduce the lubricating performance, and make the wear increase dramatically. Water and oil also react with oxidation, which, combined with a large number of metal particles from wear, can form harmful substances in the oil, which can corrode components and form sludge. At the same time, the oxidation reaction will also deteriorate or emulsify the oil, reducing the life of the oil.

The various hazards caused by moisture will not only affect the normal operation of equipment and production lines, but also greatly reduce the service life of equipment and bring great harm to the increase and value-added of industry. So, what should you do if you accidentally get into the water? Don't panic, let's go in four steps!

The first step is to power off and shut down.Water ingress into the equipment can easily lead to safety accidents, so remember to cut off the power supply and clean up other hidden dangers when dealing with it to ensure environmental safety. While protecting the equipment, it also protects personal safety.

The second step is to clean up and check.Clean up the sludge and dirt on and off the equipment in a timely manner, check whether the equipment is damaged when the situation allows, and deal with it in time.

The third step is to change the old oil to new oil.If there is a lot of water intake, the old lubricating oil needs to be extracted and replaced with a new pure lubricating oil to avoid greater losses. If the amount of water inlet is small, Sany's dewatering filtration service can purify the lubricating oil, avoid waste, reduce waste oil emissions, and reduce the cost of oil change.

The fourth step is to test run at light load.After the cleaning inspection and oil change operation are all completed, turn on the machine and turn on the power supply, and run at light load. During light load operation, it is necessary to carefully check whether the parts are operating normally, whether the oil supply is normal, whether the parts are well sealed, whether the performance of the equipment meets the standards, and once there is any small abnormality, it must be dealt with in time, otherwise the chain reaction will cause greater losses! Once everything shows up in good condition, it's time to start working normally.

The damage to the oil and equipment is huge, but in fact, many times it can be avoided, therefore, the early protection work is very important, if you can not enter the water, you can not enter the water, you can detect it early, and deal with it early!Thousands of questions for maintenance, you ask and I will answer. If you encounter other problems in the use of the device, please leave a message to communicate, and Brother Chong will try his best to answer for you.